[christianw.]

Ich sehe wir verstehen uns.

---

Unabhängig vom Reset, kommt die Karte zwar jetzt hoch, startet aber nicht in den High-Speed-Mode.

Eine funktionierende Karte tut dies:

Zitat:© Copyright 2005-2006 Creative Technology Ltd
MICROPOD FW Ver 8.4.071119 14:20:20
UPGRADE image heap free scratch 35648 loadstore 2016 extram 35616
Starting conm
| rrrj
Bus power, low speed
Starting UI task ... heap free scratch 17216 loadstore 2016 extram 30592
Tasks started heap free scratch 17216 loadstore 2016 extram 30592
Init done heap free scratch 17216 loadstore 2016 extram 30048
Initializing Diag task ... heap free scratch 17216 loadstore 2016 extram 30048
Done... heap free scratch 16160 loadstore 2016 extram 28192
Bus reset
Bus reset
Starting Diag task ... heap free scratch 16160 loadstore 2016 extram 28192
pDebugControl=0xc0baa4
Done... heap free scratch 16032 loadstore 2016 extram 28192
test point addr = 0x200018, value = 0xabcdef00
Bus reset
Bus reset
Full power
Power event, mbFullPower 1
Mono Button out/off/released.

S/PDIF Select Button out/off/released.

48V Phantom Button out/off/released.

Direct Monitor Button out/off/released.

StateInternal -> action New_Sample_Rate @ 640 ms
Start pipes, USB high speed
New sample rate 48000, high speed
StateInternal -> action New_Sample_Rate @ 770 ms